|
Tips
Switches
Light and Warmer Switch _ turns on heat lamp and
optional strip heater under corn pan.
Kettle Motor Switch _ turns on motor that drives
kettle agitator shaft.
Kettle Heat Switch _ turns on heat element inside
kettle.
DO NOT COVER VENT
HOLES!!!!
DO NOT TOUCH KETTLE WHILE IT IS HOT!!
To Pop
1. Turn on kettle heat, kettle motor, and light and warmer
switch.
2. Fill kettle with pre-measured oil and allow to
heat for approximately 10 minutes. Add
pre-measured popcorn to kettle and
close lid.
3. When corn has popped, rotate the handle to empty
popcorn from kettle; return kettle to upright position. |
|
4. Repeat the cycle; subsequent batches are always
more flavorful than the initial batch.
5. Turn off the kettle heat switch on the final batch
when the popcorn breaks over the lid of the kettle to eliminate smoke and
odor.
6. Turn off kettle heat and kettle motor.
7. Wipe exterior of kettle with heavy cloth after
cooling of kettle to prevent burn or stain of oil drippings.
8. Allow the kettle to cool until it is warm enough
to handle.
10. Unplug kettle and remove from machine.
11. Wipe kettle, kettle lids, cross bar, inside and
exterior clean....DO NOT IMMERSE IN WATER!!
|
